What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 27.06.2025 23:52
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
What is lightning?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Why did lobsters evolve bright colors if they are neither poisonous nor venomous?
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where this question deviates from being a 'generic' question, and becomes more specific.
a photo is worth a thousand words.
'Good Night & Good Luck' on CNN: George Clooney's Latest Live TV Plea - IndieWire
These devices are installed between the “hot” and “neutral” and protective ground.
In schematic diagrams this is the symbol for a fuse:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
On Which Part of the Body Might One Wear Winklepickers? - Slate Magazine
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
I post the exact comment here.
Upvotes:
Will you share your wife? Can she take both of us at the same time?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[image of Common-mode choke]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Jaw-Dropping Explosions on The Sun Captured in First NASA PUNCH Images - ScienceAlert
2024–10–14 [Omar Gharbi Omar Gharbi ]
what exactly is a ‘surge’ protector?
This one hit behind the barn.
So, the voltage could go up to 500 volts, and the fuse will not open up.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
The third is lightning and “how it gets conducted into a home.”
the problem then depends on "how fast does the fuse operate?".
Do liberals realise that God, who is much more powerful than them, is on the side of Trump?
Because the load is inductive, the current lags the voltage.(by a bit).
For this case there are devices called Metal oxide varistors (MOV).
The MOV will conduct when the voltage exceeds 50% of line voltage.
Crashed lander looks back at Earth from the moon photo of the day for June 10, 2025 - Space
A circuit breaker is similar, but is resettable.
He then asserts :
Barnstars:
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It seems Mohan does not understand the difference between a comment and an Answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
He then describes Rainy Season and Lightning.
One is “what exactly is in a ‘surge protector’ ? ”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
At one ohm, the resistor has a maximum of 1 watt power.
An AC voltage/ current source, and an ac inductive load.
Edit 2024–10.
2024–10–10[John johnson John Johnson ]
There are three different concepts here that are getting confused.
The bolt then partially travels down the line to your home.
Here is a simplified AC power diagram.
nine
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At least they know the answer if they wanted it.
There are two important concepts here.
(Dc diagram shown, AC is similar).
This is 'the assistant's answer'
One
but I think this circuit , shows a few more pieces.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
A fuse is a non-resetable over current circuit protector.
First Sentence:
These are simplified answers to the original question, and does not change anything I wrote above.
but this device (an Inductor) … impedes the rapid changes in the current.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
But it can get overloaded, and no longer works.
[old diagram got deleted by accident]
This is where the MOV conducts again, and dissipated the energy.
This device then solves the entire problem.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
He then describes the function of a fuse.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The other is “what does a “fuse” do?”
Now when you have a certain ac resistance, then a current flows in a loop.
eight
so, what happens?
What does a fuse do?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.